Reshaper forum

Error with Texture Mapping
Page 1 of 1

Author:  sadae [ Thu Aug 04, 2016 6:11 pm ]
Post subject:  Error with Texture Mapping


I´m trying to project a photo with texture mapping on a mesh, but when I press the button "Preview" appear this error:

Warning! Some texture could not be applied because the camera definition could not be determined.

Someone fix this error? :cry:

Author:  sadae [ Thu Aug 04, 2016 10:41 pm ]
Post subject:  Re: Error with Texture Mapping

Ok, I think that I found the error. This error appear because I had another previous texture, and I'm projecting new images from my camera in order to improve the texture.

If I remove the previous texture the software works correctly, but the problem is that I need the previous texture to find couple points... Exist any way to put the new texture visualizing the old texture? Thanks!

And exists any way to save the reference points added? Because this would be a way to resolve my problem .It would be fantastic if exist any way to export the reference points located in the texture mapping. I know that I can import a .txt with the texture reference point and exists a button to export but this always is unavailable.

PD: I found the way to export the reference points, pressing the Preview this button is available, and I can save the references. Then, I have to save all the references from all the photos, delete the previous texture and load the references of each photo. I will try it :D

Author:  sadae [ Fri Aug 05, 2016 8:04 am ]
Post subject:  Re: Error with Texture Mapping

Another update, to activate the export button is necessary to press the photo to export the points referenced, not the preview button.

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group